. We recommend powering the camcorder from a household power source. With some types of tapes, the remaining tape display may not be accurate. Mastering Basicsthe The built-inspeaker is monaural. Connect the S-150 S-videoCable to the S-videoterminals. For example, it has a rubber coated grip and a 4x optical zoom.
. To adjust for daylight saving time, select the time zone with the Unext to the area. When you have finished printing: 1. You cannot record from tapes with copyright protective signals. Reselect the card mix image when you have turned off the camcorder, changed the position of the program selector or removed the memory card. The camcorder goes into stop mode after 5 minutes in reverse playback pause. Bright light or reflected light may cause a vertical light bar to appear on the screen.
The size of the still image will be 640 × 480. . . The range depends upon the recording condition. Depending on the signal sent from the connected device, the conversion from analog to digital signals might not work properly e. The degree of reduction depends upon the distance and on each individual.
You can also format a memory card to erase all images recorded on it. The trimming setting applies only to one image. Card Up to 6 images appear. Insert the memory card all the way into the memory card slot. You can display a single image, 6 at one time index screen 116 , or one after another slide show 117. The image quality may be slightly lower with digital effects. Close the cassette compartment cover.
Keep the button pressed for over 2 seconds. Return cassettes in the case and store them upright. Using Digital Effects You can use the digital effects during recording and playback. The year display starts to flash. Do not change the mode during recording as the brightness of the image may change abruptly. Date search: Playback may start slightly before or after the date change.
There is no need to turn off the image stabilizer during normal recording. . Do not turn off the camcorder, disconnect the power source, open the memory card cover or remove the memory card while the card access indicator is flashing. Date search may not function if the data code is not correctly displayed. For extra recording time, see Changing the Recording Mode 51. Press and hold the button during normal playback or fast forward. Set the program selector to Q.
Camcorder displays appear in Chinese. Images are played back one after another. Warm it in your pocket before use. Make sure to insert a memory card that contains images. After use, turn off the camcorder and disconnect the power adapter from the camcorder. Do not turn off the camcorder, disconnect the power source, open the memory card cover or remove the memory card while the card access indicator is flashing. A still image recorded from an image in 16:9 format will be vertically compressed.
Set the program selector to Q. Condensation Moving the camcorder rapidly between hot and cold temperature may cause condensation water droplets to form on its internal surfaces. Refer also to the instruction manual of the connected device. Refer also to the instruction manual of the respective printer. Table of Contents Introduction Reference Guide. E Power Source Problem Cause Solution Camcorder will not turn Battery pack is exhausted. Open the backup battery cover.
We recommend powering the camcorder from a household power source while it is connected to the computer. . This is not a malfunction. Press and release the c record review button. .