Action Install the correct cartridge for the printer region. Touch something metal such as the printer frame before you touch a memory card. Remove the right side cover. Warning: Printer memory memory cards are easily damaged by static electricity. Push the latches away from the card on both ends of the memory card connector. Disconnect the input sensor cable A from the input sensor B. Printing label applications on your printer requires a special label fuser cleaner which prevents duplexing.
When ordering pick rollers, you need one set per input tray excluding the multipurpose feeder. Open the upper and lower front covers. An error has been detected. This error code indicates a mismatch between the operator panel board and the 2. Lift the front edge of the finisher output bin cover until it locks into position. All information is subject to change without notice. Disconnect the autocompensator motor cable A from the system board J24.
Replace the screw securing the sensor cover. Place the spring on the left pin A. Note the thermistor cable routing A and disconnect the thermistor cable at the fuser control board. From a word Jobs or Print and Hold, then follow the driver instructions. Open the printer rear door. With a thumbnail, release the catches B holding the sensor cover to the lower exit guide Hold the narrow media flag out of the way to remove the sensor from the cover. You can also set the output type for media such as card stock or envelope sizes that cannot be sent to an optional output bin.
This error displays when too many disks are attached to the printer. Warning: Do not touch the photoconductor drum on the underside of the cartridge. Remove the two screws B securing the left frame extension. Remove the washer, and set it aside. Overfilling the tray may cause jams. Reconnect the printhead laser cable.
Identifying and linking output bins. Overfilling the tray may cause jams. To set the system password: Open your Web browser. Lexmark recommends that the number of pages per month be within the stated range for optimum device performance, based on factors including: supplies replacement intervals, paper loading intervals, speed, and typical customer usage. Note: When right, and push the shaft from the outside of the frame. Printing label applications on your printer requires a special label fuser cleaner which prevents duplexing. Once a component has been installed in a printer, it can not be used in another printer.
Place the printer on its side. For more information about installing input options, see Installing and removing options or the instructions that came with the option. Some types of installed in a printer, it can not be used in another printer. A clock face appears on the display. Lift the envelope feeder up out of the printer, and then set it aside. If Tray 1Missing is still displayed, replace the system board assembly.
Initially 0000 displays with the maximum fail count being 999,999. Press down on the staple guard until it snaps securely into place. Lift the left side of the fuser transfer plate A , and move the plate to plate ground wire to the center pan. Do not mix sizes and types in the same tray. Place the duplex unit on top of any installed drawers or the table or printer cabinet where you plan to use the printer. Remove screw H that attaches the side fuser lamp contact to the fuser top cover. Rotate the bent end C of the spring to add tension, place the pins between the sensor cover arms, and rest the bent end against the sensor cover frame.
A-5 Removing or installing a memory card. Part or all of the page is printed in black. Remove the integrated tray autocompensator assembly. Align the keyholes on the shield with the screws on the frame. To clear these areas: Open the printer paper tray, and remove any jammed media. Press to clear the message. Lexmark is not responsible for the use of other replacement parts.