Remove the wiring harness rubber band from the handlebar 7. Apply a thin coat of rubber adhesive onto the left end of the handlebar. Unsmooth operaton Replace starter clutch assembly 2. First heading This is a chapter with a symbol at the top right-hand side of each page. Therefore, the charge of the battery has to be checked by measuring the voltage at the battery terminals. Stand the scooter on a level surface.
Disconnect the headlight lead Removing and installing the each time a cowling or panel needs to connectors, the turn signal cou- cowling and panel be removed and installed. Remove the burnt-out bulb from 1. Replace all gaskets, seals and O-rings when overhauling the engine. Adjusting nut page 6-13 9. Do not ding the tires, should be left to tires. Tripmeter To reset the tripmeter, select it by 7. Storage compartment page 3-11 6.
Throttle cable free play The throttle cable free play should 1. Clutch - stall revolution 5. Grab bar page 5-2 6. Scalding hot fluid and steam may be blown out, which could cause serious injury. Thermo switch 16 Nm 1. Mixing brake fluids may result in a harmful che- mical reaction, leading to poor brake performance.
Stand the scooter on a level surface. Carburetor Carb Stage 1-7 Jet Kit. Record the information on this label in the space provided. Rear brake lever page 3-7 5. The key can be removed. Warm it up for several minutes, and then stop it.
Stand the scooter on a level surface. Air filter element page 6-9 3. If the head- light bulb gets soiled, thoroughly clean it with a cloth moistened with alcohol or lacquer thinner. Second heading This title appears at the top of each page to the left of the chapter symbol. Final transmission oil filler cap page 6-7 8. If incorrect operation is suspected, inspect the following: 1. If any of the readings indicate no continuity, repla- ce the bulb socket.
Haynes Twist and Go Automatic Transmission Scooter Repair Manual This Haynes Twist. Left handlebar switches page 3-6 6. Switch the turn signals off. When placing an order, refer to the list provided below to avoid any mistakes. This information will be needed when ordering spare parts from a Yamaha dealer.
Ope- The tire air pressure must be lity, and safe operation of your vehi- ration of an overloaded vehicle adjusted in accordance with cle, note the following points regar-. Luggage hook page 3-13 3. To install the fuel tank cap, turn it 1. When assembling, pleaseuse the applicable service manual. Insert a new bulb into the socket. Speedometer Do not operate the vehicle until you. Before using this vehicle, check the following points:.
The starter motor fails to turn. Obey all safety messages that follow this symbol to avoid possible injury or death. If this occurs, flashing, push the button to set it. To avoid been designed, tested, and approved. Battery The engine turns over The battery is good. C St-Quentin B 329 035 422 2012-03 E. If coolant is not available, tap water can be temporarily used instead, provided that it is changed to the recommended coolant as soon as possible.